Whirlpool Bath – Electronic Control Instructions

Control Panel

  • ON / OFF: Turns the control panel - press the button on or off for approximately 5 seconds to put the Jacuzzi ON.
  • Safety Lock: Activates or deactivates the safety lock system.
  • Water / Air Jets: Starts the hydromassage system.
  • Air Jets: Starts the air system.
  • Light / Chromotherapy: Turns the underwater light or chromotherapy on or off.
  • Ozone Disinfection: Starts the ozone disinfection function.
  • Heater: Turns on the water heater - this only maintaing water hot. 
  • + Increases the temperature or volume.
  • - Decreases the temperature or volume.
  • Radio / Bluetooth: Activates the radio or Bluetooth function.
  • TUN: Selects radio frequencies.
  • VOL: Selects the volume.

Important

Please make sure the water level is always above the line shown in the picture. This is necessary for the jacuzzi system to work properly.

Safety Lock

If no function is activated on the control panel for 5 consecutive minutes, the safety lock will activate automatically and only the LCD screen will remain on.

To unlock the control panel, press and hold the safety lock button for 3 seconds. To activate the lock again, press and hold the same button for another 3 seconds.

Hydromassage System

This button activates the hydromassage system.

If the water level is too low, a warning symbol will appear on the control panel screen and the system will not start.

Air System

This button activates the air system.

Underwater Light / Chromotherapy

Press this button to turn the underwater light or chromotherapy function on or off.

Ozone Disinfection

After each use, and only when the bathtub is empty, press this button to start the ozone disinfection function.

The function switches off automatically after approximately 10 minutes.

Heater and Temperature Setting

This function allows you to turn on the heater, but only when the water system is running.

The control panel shows the current water temperature. Use the + and - buttons to select the desired temperature.

Radio / Bluetooth

Press this button once to activate the radio. Press it twice to activate Bluetooth.

To connect Bluetooth, first turn on Bluetooth on your phone, search for available devices and connect to the bath system.

Saving Radio Frequencies

Press the frequency button and a preset frequency will appear on the screen.

Use the + and - buttons to change the frequency until you find the station you want to listen to.

After a few seconds, the frequency will be saved automatically.

You can save up to 10 radio stations and later select them from 1 to 10.

Volume

Press the volume button and the control panel will show the current volume level.

Use the + and - buttons to select the desired volume.